I have a Model 989G. I’m having trouble with it shooting automatically when I pull the bolt back then release it. It automatically shoots. I tried two bullets, the both went off without pulling the trigger. Any suggestions would be helpful. Maybe a bad sear, maybe really dirty deep inside. I’m open for suggestions.
Sam
Model 989G
Moderators: Regnier (gunrunner), JohnK, Sure-Shot
-
- Beginner
- Posts: 1
- Joined: Wed Dec 04, 2019 7:23 am
Re: Model 989G
It doesn't sound like anything major, although it is potentially dangerous in its current situation. I would start with a thorough cleaning or the trigger/sear group. Sounds like there is some "gunk" built-up in the sear notch preventing the sear from capturing the trigger. Here's a link to help get you started:
https://www.marlinowners.com/forum/rimf ... uto-2.html
Also check the old buffer...it probably needs replacing if it's the factory origional.
You have youself a very fine rifle. Don't give-up and sell it!
https://www.marlinowners.com/forum/rimf ... uto-2.html
Also check the old buffer...it probably needs replacing if it's the factory origional.
You have youself a very fine rifle. Don't give-up and sell it!