Older 39a jamming

Anything to do with gun smithing.
Post Reply
Gunney
Beginner
Posts: 2
Joined: Fri Jul 21, 2017 8:21 pm

Older 39a jamming

Post by Gunney »

I have a Mountie 39a that usually jams when I try to install a round. It's been at a gun shop for a year with the smith saying the carrier assembly is bad and he can't find one. Recommendations on parts locations or where I can send it to get it repaired
Brent
Sharpshooter
Posts: 307
Joined: Tue Sep 30, 2008 11:24 am

Re: Older 39a jamming

Post by Brent »

Here is one,
http://www.ebay.com/itm/Marlin-model-39 ... SwY4pZX~YS

Another
http://www.ebay.com/itm/Marlin-39A-Carr ... SwmgJY3YJz

and another
http://www.ebay.com/itm/Marlin-39A-Comp ... SwCQZZNIzp

I imagine there are several for sale on Gunbroker as well.

They are VERY easy parts to find. You need a new gunsmith that wants to work.

But I have doubts your carrier needs to be replaced. On the other hand, I am not a gunsmith - not even on the internet or TV.

How old is your rifle?
Gunney
Beginner
Posts: 2
Joined: Fri Jul 21, 2017 8:21 pm

Re: Older 39a jamming

Post by Gunney »

I was told that I needed the old carrier assembly. Are this for the older models 1958
Regnier (gunrunner)
Distinguished Expert
Posts: 4667
Joined: Sun Oct 27, 2002 2:33 am
Location: The Sunflower State

Re: Older 39a jamming

Post by Regnier (gunrunner) »

Gunny;

The carrier consists of three parts. The carrier, the rocker and spring. If the rocker is worn, or the spring is weak, then the carrier will not work. I would think that the carrier itself is okay, which means you should start by replacing the rocker and spring. Those parts should be available at Numrich Parts Corporation.
If not, keep an eye on eBay and Gun Broker.
Good luck..............
Due to the increasing cost of ammunition, there will be no warning shot!

The growing federal deficit = generational slavery to the national debt.

If the world was perfect.......it wouldn't be.
Brent
Sharpshooter
Posts: 307
Joined: Tue Sep 30, 2008 11:24 am

Re: Older 39a jamming

Post by Brent »

User avatar
marlinman93
Distinguished Expert
Posts: 2853
Joined: Sun Nov 10, 2002 1:22 pm
Location: Portland, Oregon

Re: Older 39a jamming

Post by marlinman93 »

It's nearly impossible to wear out the carrier! I'd agree with Regnier that it likely needs a new rocker, or possibly some lever wear. But the carrier is not likely the issue. I'd also second that you may need a new gunsmith who understands lever guns, especially Marlins.
Marlin lever actions 1870's-WWI, Ballards, and single shot rifles!
Post Reply